Inducer Motor Replacement

April 21, 2024 Post a Comment

Inducer motor replacement

A replacement draft inducer motor will cost between $500 and $700. These motors are specific to manufacturers, so it can be harder to find the exact model needed. Technicians may not have the specific model on hand during emergency repair jobs at odd hours. Repairs cost less, with prices ranging from $250-$450.

What causes an inducer motor to fail?

Most inducer motors failures are simply attributed to the older age of the furnace. In most cases, the internal bearings wear out and since the unit is a sealed unit, there is no way to repair the original motor. Instead the unit is simply replaced with a new one.

How long does an inducer motor last?

Furnace inducer motors can have a life expectancy of 12-15 years. A replacement furnace inducer motor can cost around $800.

Can you run a furnace without an inducer motor?

Although it's a fairly simple component, inducer motors have one of the highest failure rates of any part within a furnace. A failing inducer motor often creates bothersome noises and reduces the efficiency of the furnace. If it gives out completely, your furnace will be unable to provide heat altogether.

What's the most expensive part of a furnace?

The three most expensive parts on a furnace are the blower motor, the circuit board and the draft inducer motor.

How long does it take to replace inducer motor?

Replacing a furnace inducer motor takes 30 to 60 minutes, depending on inspection time, accessibility, and wiring requirements. Most HVAC technicians charge a minimum service fee regardless of the time spent that includes up to one hour of labor.

What happens if the inducer motor stops working?

If the inducer motor doesn't turn on when it's supposed to, the furnace will recognize this and shut down. It will wait a bit and try again. If the motor doesn't start after 3 to 5 tries, the control board will stop sending voltage to the inducer motor, and essentially locking it out from attempting it anymore.

How much does an HVAC inducer motor cost?

The average furnace inducer motor cost is around $245, when the part is under warranty and you pay only the labor to have it installed. The replacement cost is $465 when the warranty has expired and you pay for the furnace inducer motor.

What does a bad inducer motor sound like?

A failing inducer motor may create a noise shortly after a heating cycle begins. This could be a tapping noise, or a humming or whirring sound. If the unit will turn on but the blower motor is not turning on, there are a couple of ways to check if the draft inducer motor has gone bad.

Should I replace a 15 year old furnace?

After about 15 years or so, you may need to consider a furnace replacement if your unit has been experiencing significant problems and requiring frequent repairs. You can extend the lifespan of your furnace by performing regular maintenance, including changing the filters and cleaning the burners.

Can you lubricate an inducer motor?

And one motor oil three and motor one three and one motor oil is a special blend for furnace motors

What safety protects a furnace if the inducer motor fails?

A furnace pressure switch is an automatic safety feature located near the motor. It shuts the furnace down if it senses negative pressure created by the draft inducer motor. This protects your home from dangerous backdrafting, which is when exhaust fumes are reintroduced into the system.

Does the inducer motor run with air conditioning?

So the inducer will only run when your furnace is actively trying to heat the air, while the main fan could run any time you want the HVAC system to move air through your house.

Can you lubricate furnace inducer motor?

Furnace Maintenance If the motor has oil ports, it should be lubricated annually. Apply two or three drops of 10-weight nondetergent motor oil (not all-purpose oil) to each port. Do not overlubricate. If the blower shaft has oil ports, it, too, should be lubricated annually, following the same procedure.

How do you test an inducer motor?

Use a multimeter on the voltage setting to test power going to the inducer motor. Probe the hot (black wire) and neutral (white wire). ... Inducer fan motor electrical and power issues

Check if the board is getting power.
Use your multimeter to test between the R and C terminals on your control board.

What furnace lasts the longest?

In general, oil-fueled furnaces have the longest life expectancy, and gas-fired furnaces have the shortest.

How much should I budget for a new furnace?

A new furnace replacement can cost between $3,000 - $7,600, depending on the size of your home, the efficiency of your new furnace, and the sophistication of the equipment. That includes labor and permit fees, not just equipment costs.

Is a 90 percent furnace worth it?

The 90% furnace is more efficient because it burns gas more efficiently, but there are many more options available to save energy and increase home comfort. Many of these models offer an electronically commutated blower motor or ECM, which runs continuously at variable speeds and heats the house more consistently.

Where is the inducer motor located?

We recommend shutting off the gas supply as well the draft inducer fan motor is normally located in

Why is my inducer motor filling with water?

one cause is an improperly pitched vent pipe. If the pipe doesn't have the proper pitch back towards the furnace, it will fill with water while the furnace is running. As soon as it shuts off, the water rushes back towards the furnace, overloads the in-line drain fitting, and ends up in the inducer.